Actually did something similar a few years ago. I ordered a big batch of
prime steaks for a party we were having from one of those mail order places.
They came packed in a nice big bare Styrofoam cooler with 2" thick walls.
To good to throw away so I covered it in epoxy and 6oz glass. I have a
feeling it would run circles around anything on the market for keeping ice.

--
Glenn Ashmore

I'm building a 45' cutter in strip/composite. Watch my progress (or lack
there of) at: http://www.rutuonline.com
Shameless Commercial Division: http://www.spade-anchor-us.com

"BF" wrote in message
...
Did that 20 or so years ago, except used 2" sheet eps home insulation
instead of a premade cooler. Made it custom to fit between the second and
third thwart on a 25' Old Town canoe. Not only will it hold food and beer
for 6 and keep it cold for 3 days, but also provides a quite comfy seat
for
that station on the boat. No carbon fiber, way too expensive back then.
Still in good service today.
BF


"Richard Lamb" wrote in message
link.net...
Larry wrote:

"Glenn Ashmore" wrote in
I want you to add one more cooler to the test......

Go down to the dollar stores and buy the biggest cheap styrofoam
cooler,
the one that just styrofoam and $6 you can find.

Test it to and it'll wipe the nose of all the others....(c;

Floats, too, even fulla beer!...(c;


And they can make a interesting fiberglass practice project.

This is a good sanity check for anyone thinking of building a
fiberglass airplane. (sorta also applies to glass boats?)

If you can make a nice looking glass cooler, you might be able
to build a nice airplane - or boat.
Otherwise, do something else.

Ultimate Beer Cooler Project:

Select a cheap Styrofoam cooler.

Using 5 ounce BID, and epoxy resin (!), glass micro balloons, and
chopper cotton fiber --- cover the cooler.

Plan on 4 layers on the bottom, 3 on the out sides, and 2 insides
and 4 on the floor(!). 1" overlaps typical.

2 layers BID on the lid.

Don't forget to prep the lid / cooler clearances!

Probably easier to take some off of the bottom of lid than to attack
the inside edge of the cooler. Lay some extra glass tape along the
contact area of the lid. Sand for a tight fit when it's all solid.

If you just happen to have some of that neato looking carbon fiber tape
handy, add a wrap around the cooler during the lay-up.

- and - presto -

the World's First
Carbon Fiber Reinforced
Beer Cooler!


In the end, if it looks nice and weighs less than 10 pounds?

If the wife points it out, "can you believe HE made that?".

If you didn't break out in hives, or scratch rashes.

And found you are allergic to latex (nitryl gloves).


It's almost kinda fun.

sorta...