|
High Times
On Mon, 19 Dec 2005 13:14:53 -0500, "Skip Gundlach" skipgundlach at
gmail dotcom wrote: Well, up the mast, anyway! This has probably been covered to death, but I think I recall discussions in this space before about improvements on the typical bosun chair to the effect of good mountain climbing gear. Looking at climbing harnesses on REI, a frequently mentioned retailer of such stuff, the harnesses I see don't look the least bit like I'd have expected. Are there any here with experience in this sort of gear? What should we look for for up-the-mast use (in place of the bosun chair, of which I have a fine one, but this is supposed to be far superior in comfort and safety)? Thanks. L8R I just picked up Hal Roth's "How to Sail Around the World" and while there's a fair bit of repetition from his earlier books, it's a good solid compendium. I noticed that all his boats had and have pretty solid-looking mast steps. I would say this is the way to go for a cruiser unless there's a compelling reason not to just resort to an ATN Climber or some similar piece of mountaineering kit. R. |
High Times
I've tried that Bachman knot, they say it slips on icy rope, I know
from experience it also slips on muddy rope. |
High Times
|
High Times
Commodore Joe Redcloud© wrote:
I just picked up Hal Roth's "How to Sail Around the World" and while there's a fair bit of repetition from his earlier books, it's a good solid compendium. I noticed that all his boats had and have pretty solid-looking mast steps. I would say this is the way to go for a cruiser unless there's a compelling reason not to just resort to an ATN Climber or some similar piece of mountaineering kit. R. There are a few drawbacks to mast steps, not the least of which is galvanic corrosion weakening the mast. The mounting plate may prevent you from seeing the damage until the mast collapses. Commodore Joe Redcloud© I heard the biggest complaint is noise in strong wnds. |
High Times
Another possibility is to use an "Etrier" which is a sort of webbing
ladder that you could hang from your halyard. You would make it from 1" tubular webbing with steps tied every 2'. You might even find a cable ladder from a climbing supply place. However, climbing either one is harder than it sounds. The admonition about a safety rope strongly applies here. For that matter, why not have holes for steps pre-drilled in your mast but do not put the steps on. Instead, they'd have captive studs that would slip into a slot with an opening at the top of the slot into which the stud would fit and then would be pulled about 1/2" down into the slot. You would then need very few steps as you would climb and pull up the ones below you as you went up. I dont really think this would work well. |
High Times
$500, MY GOD. My system cost me maybe $20. But, Petzl always wuz
xpensive stuff. I do agree about lessons cuz its really easy to make mistakes. I've seen people fasten their harnesses with Fastek buckles, maybe they got lucky and are still alive. When I was really into cavin, eventually I decided to always be the last out of a pit cuz invariably, otherwise I'd have to go back down to help some poor fool who went in not knowin how to use his mechanical ascenders. Half the time I'd tie him some prisiks and make him a believer in them. |
High Times
On Thu, 22 Dec 2005 22:19:57 GMT, Commodore Joe Redcloud
wrote: When the mast comes down in strong winds it makes quite a racket! ====================== Indeed it does. Another issue with mast steps is that they tend to snag halyards in awkward ways that mandate a trip aloft just to undo the mess. |
High Times
$500, MY GOD. My system cost me maybe $20. But, Petzl always wuz
xpensive stuff. I do agree about lessons cuz its really easy to make mistakes. I've seen people fasten their harnesses with Fastek buckles, maybe they got lucky and are still alive. When I was really into cavin, eventually I decided to always be the last out of a pit cuz invariably, otherwise I'd have to go back down to help some poor fool who went in not knowin how to use his mechanical ascenders. Half the time I'd tie him some prisiks and make him a believer in them. Obviously, I could talk about caving forever but I can no longer do it. Somehow, I can no longer regulate body temp so I get dehydrated very fast in spite of the near 100% humidity and cannot carry enough water to help. I get sorta wacko and do not care if I get out or not. Past two serious trips nearly killed me so I go sailing now, a sorta poor substitute for thrills. |
High Times
On Fri, 23 Dec 2005 12:17:27 GMT, Commodore Joe Redcloud
wrote: My high tech 7/8 inch line was not the cheap stuff either. ================= Why 7/8 line? I assume that is diameter? Seems like much larger than necessary unless the ascenders need that much to get a good grip. 7/8 diameter is way too heavy for a climber to be carrying around. I'd be interested in hearing about some of the safety precautions since I've done a bit of "ascending" without benefit of formal instruction. |
| All times are GMT +1. The time now is 03:24 PM. |
Powered by vBulletin® Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004 - 2014 BoatBanter.com