"Chris" wrote in message
oups.com...
I saw at the Miami boat show a salesman demonstrating an adaptor that
when attached to the drill you could adjust the angle of the drive more
than just a 90 degree fitting. (Should have bought it) I need to drill
into the coaming through heavy glass and tap into a metal backing plate
and the bottom holes clearance is less that 11/2" above the deck. Any
suggestions out there??

Thanks, Chris


Try this website... I saw a couple of models...

http://www.mytoolstore.com/compare/cpdrill2.html

--
"j" ganz @@
www.sailnow.com