| Home |
| Search |
| Today's Posts |
|
|
|
#1
|
|||
|
|||
|
On 2005-06-10, Marc Auslander wrote:
IIRC, the simple way to wire an led is with a series resistor chosen to give the rated current at the expected voltage. The LED itself has a very small resistance - as you would expect given its power efficiency. Most of the power is then comsumed by the resistor. This is indeed the simplest way, but it is generally only done when the supply voltage is regulated. The 12v system on a boat is only loosely regulated and most (well designed) electronics uses active regulation to protect the circuitry. Resistance of the LED is not really the issue, the power dissipated by it is volts times amps. The issue is that dropping voltage across the resister wastes power as heat. Hence using a switching regulator to drop the nominal 12v to the lower voltage needed by the LED is doubly beneficial - it protects the LED from spikes on the 12v and improves the efficiency significantly. -- Andy Repton |
|
#2
|
|||
|
|||
|
On 10 Jun 2005 14:34:07 GMT, Andy Repton
wrote: On 2005-06-10, Marc Auslander wrote: IIRC, the simple way to wire an led is with a series resistor chosen to give the rated current at the expected voltage. The LED itself has a very small resistance - as you would expect given its power efficiency. Most of the power is then comsumed by the resistor. This is indeed the simplest way, but it is generally only done when the supply voltage is regulated. The 12v system on a boat is only loosely regulated and most (well designed) electronics uses active regulation to protect the circuitry. Resistance of the LED is not really the issue, the power dissipated by it is volts times amps. The issue is that dropping voltage across the resister wastes power as heat. Hence using a switching regulator to drop the nominal 12v to the lower voltage needed by the LED is doubly beneficial - it protects the LED from spikes on the 12v and improves the efficiency significantly. Perhaps even better_ a two terminal constant current regulator rated for generous maximum volts to allow several LEDS in series safely.... Brian Whatcott Altus OK |
| Reply |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| How many forum members does it take to change a light bulb? | General | |||
| Red over green mast light for sailboat | Boat Building | |||
| Lightbulb? Here? | General | |||
| Light air tips - older J24 | General | |||