"Wilbur Hubbard" wrote in message
news:504a191a$0$62077

Poor Skippy!!! It sounds like your amateur attempt at alignment is doomed
to failure.

Why?

Because there is a lot more to alignment that just centering the shaft in
the log. A perfectly centered shaft can fail to be perfectly aligned with
the transmission output shaft/flange.

IOW, if the two flanges that bolt together are not perfectly parallel both
top to bottom and side to side and everywhere else, when the propeller
shaft is centered in the log there will be a terrible vibration set up as
the two flanges will bind and loosen as they rotate. The only way to get
them perfect is by using two dial gauges, one for each flange and as you
rotate them with perhaps an 18th inch of space between them (in neutral)
by hand both gauges must not move more than a blonde hair.

Sounds to me you are doing the job only halfway, Skippy.


Wilbur Hubbard


Heh. Reading deficit, eh?

We got the shaft centered. That took care of the alignment with the
cutlass. The shaft turns readily, by hand, from the skinny end outside, the
middle, next to the log, and the transmission, where I've got the coupling
mated with the bolts, but not yet tightened, as we've not yet aligned the
engine.

At this moment I'm about .005 off gap to starboard. That only happened when
I tightened down the last two of the mounts. It previously was about .003
off to bottom I was expecting that (changes as I tighten the various
elements of adjustment), of course. A couple of rounds of fiddling, and it
will be finished.

L8R

Skip

--

Morgan 461 #2
SV Flying Pig KI4MPC
See our galleries at www.justpickone.org/skip/gallery !
Follow us at http://groups.yahoo.com/group/TheFlyingPigLog
and/or http://groups.google.com/group/flyingpiglog

When a man comes to like a sea life, he is not fit to live on land.
- Dr. Samuel Johnson