Home |
Search |
Today's Posts |
|
#1
![]() |
|||
|
|||
![]()
A diode isolator is probably the last choice for a number of
reasons. A combiner is next best, something like the Eliminator or EchoCharge is the best choice IMHO. Doug s/v Callista "Bill Darden" wrote in message om... For higher reliablity, use a diode isolator. Please see Section 7.1.9 in the Car and Deep Cycle Battery FAQ on www.batterfaq.org for more information and other alternatives. Kindest regards, BiLL..... "Jeff Morris" wrote in message ... I use a combiner - a relay triggered by connect and disconnect voltages. It works, though I'm not ecstatic about it. If I were doing it again I might consider the Xantrex Echocharge, which will pass a small amount of current to the starting battery. "Gabriel Latrémouille" wrote in message ble.rogers.com... Looking for suggestions on isolating the motor cranking battery from the house deep cycle batteries both being charged by one alternator & wind generator. Gabriel |
Reply |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Forum | |||
Buying Boat Batteries - Check My Thinking | General | |||
Batteries for trolling motor on a jon boat..>>> | General | |||
Parallelling AGM starting and Golf Cart Batteries... | Cruising | |||
Cheap AGM Batteries in Charlotte NC | General |