About Us

cavelamb himself[_4_]

wrote:

On Fri, 19 Sep 2008 07:30:15 -0700 (PDT),
wrote:

On Sep 19, 7:07 am, Brian Nystrom wrote:

wrote:

On my wood Tolman Skiff, I have found a couple of places where two
layers of wood epoxied together are delaminationg. Nothing serious
but if left unfixed would lead to problems. Basically, the directions
said to paint all surfaces with thin epoxy and then before it cured to
spread the thicker and then to join the pieces. So, how am I getting
delamination?
I live in Florida so it is subject to extreme humidity and heat.

I think you may have misinterpreted the directions. For laminating, you
need to coat both surfaces with epoxy and allow it to soak into the
wood. You may need to apply more to areas that are particularly
absorbent. Once the surface is sealed, you need to thicken a batch of
epoxy with silica, wood flour, microballoons, etc. and spread that over
the surfaces to be laminated. Clamp the surfaces lightly and allow it to
cure. The purpose of the thickener and light clamping is to prevent the
epoxy from being squeezed out of the joint.

This is West System epoxy and when I mean thinned I mean I simply have
not added thickener like microballoons or microfiber. I did not add
thinner. The epoxy straight from the pumps is mixed and painteed on
the bare wood and allowed to soak in, Then microfiber is then added
to thicken it and strengthen the joint, smeared on evenly and the two
parts are then joined with screws to hold them together. small
amounts of delamination has occurred at two joints that were not
covered with glass

The wood may have been contaminated in those spots. The epoxy may not
have been completely mixed, you may have used fast hardener rather
than the proper slow hardenener. Then there is the issue of UV
exposure.

Lot of things can go wrong. Most of them are easy to avoid with a
little care.

And, in the end, it's the glass that makes a water resistant barrier.
No glass, huh?

--

Richard

(remove the X to email)

Thread Tools	Search this Thread
Show Printable Version	Search this Thread: Advanced Search
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Deck delamination, purchase question, how to do the deal .. question	Lester Evans	Boat Building	4	June 5th 06 10:12 PM
Delamination, Dodger snaps, and boat Purchase	Lester Evans	Cruising	4	May 17th 06 07:03 AM
Epoxy fibreglass on top of epoxy primer	seagoat	Boat Building	2	December 1st 05 11:59 AM
Old epoxy--somewhat OT (but it's an epoxy question)	David Todtman	Boat Building	10	June 5th 05 03:45 PM
Delamination repair	Oysters8	Boat Building	3	September 25th 04 06:53 AM

Menu

About Us