Home |
Search |
Today's Posts |
#1
posted to rec.boats.building
|
|||
|
|||
aluminum hull as chassis ground?
In fresh water, is there any reason an aluminum hull couldn't be used as a
chassis ground, as in vehicles back when they were made of metal? It would alloy single conductors to be run to most devices. |
#2
posted to rec.boats.building
|
|||
|
|||
aluminum hull as chassis ground?
On Mon, 10 Sep 2007 14:06:44 GMT, "bill allemann"
wrote: In fresh water, is there any reason an aluminum hull couldn't be used as a chassis ground, as in vehicles back when they were made of metal? It would alloy single conductors to be run to most devices. Better seperate the juice from the hull, I'd think. It only takes about a half volt to provide cathodic protection - or just as easily, anodic corrosion. A half volt drop to an aluminum conductor is not out of the way. Brian W |
#3
posted to rec.boats.building
|
|||
|
|||
aluminum hull as chassis ground?
Don't even think about it! Your aluminum hull could look like swiss cheese
in short order. Make NO electrical connections to your hull. Run an insulated reurn line to battery negative. Steve "bill allemann" wrote in message et... In fresh water, is there any reason an aluminum hull couldn't be used as a chassis ground, as in vehicles back when they were made of metal? It would alloy single conductors to be run to most devices. |
Reply |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
Ground Plane for aluminum boat | Electronics | |||
use aluminum toe rails as SSB ground? | Electronics | |||
Steel hull - electrical ground | Electronics | |||
Steel hull - electrical ground | ASA | |||
Steel hull - electrical ground | Boat Building |