| Home |
| Search |
| Today's Posts |
|
#10
posted to rec.boats.building
|
|||
|
|||
bolt metal type in aluminum mast
On Sun, 27 May 2007 20:26:14 -0400, Dan "dhapp-at-wmis,net" wrote:
Brian Whatcott wrote: Aluminum riv-nuts are easily obtained, easily fitted, and reasonably replaceable when the time comes. Screw a SS screw into a riv-nut Brian, do you have a link to a source for these riv-nuts? I can't seem to find them. I googled "riv-nut" for 30,000 hits. I googled "riv-nut supplier" for 3000 hits. Here is one of them. It has a cross-section diagram to give you the idea http://www.cardinalcomponents.com/fasteners.htm Brian Whatcott Altus OK |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| Source for aluminum non-folding mast steps | Cruising | |||
| self stepping my mast. | General | |||
| keel stepped/deck stepped masts | Cruising | |||
| Ignorant Dupes | ASA | |||
| FJ 2 Silverback Sheet Metal - Aluminum Dingy 12'x5' | Boat Building | |||
Threaded Mode
