bolt metal type in aluminum mast
On 27 May 2007 10:55:18 -0700, CB wrote:
Time will tell.. I'm sure it's fine for the application. Thanks for
everyone's comments, especially those regarding the aluminum riv-nuts.
I will look into those for next time.
Cheers,
-CB
Riv-nuts cost peanuts and go on with a pop rivet gun.
But if you were paranoid about electrolytic corrosion, there is a
species of rubber expanding nut with an internal metal threaded
insert. That might suit some low strength applications too.
Brian Whatcott Altus OK
|