Home |
Search |
Today's Posts |
#22
|
|||
|
|||
zero clearance cutting tools?
"Evan Gatehouse" wrote in message ... I am going to trim some plywood frames that intersect the hull right at the shoulder position of a few quarterberths. These are either 1/4" or 3/8" plywood frames, tabbed both sides to the hull. By the Just a thought. If these plywood frames were installed using good fiberglass/marine practices, the would be a strip of foam between the edge of the ply and the hull. Among other thing, it also forms fillet for the tabbing. If your lucky and the builder put this foam strip in, then you can just grind the glass down with the edge of a cutting wheel, until you get to the foam, same on the other side. Cut ply perpendicular to the this kerf and break it off in sections. Good luck. Steve s/v Good Intentions |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
where to buy volvo tools? | General | |||
opinions sought for full-time cruiser Tools and Spares selection | Boat Building | |||
Cutting fibreglass | Boat Building | |||
Cutting Fiberglass-Rotary Cutter | Boat Building | |||
The *best* knife for cutting fish into bait... | General |