LinkBack Thread Tools Search this Thread Display Modes
Prev Previous Post   Next Post Next
  #11   Report Post  
posted to rec.boats.building
 
Posts: n/a
Default Keel cooler cast into lead

Glenn, Your in the keel cooler will work fine, it should also work on
the hard if that side of the keel is not in direct sunlight all day.
Don't forget that these compressors without fan cooling depend only
on super-cooled refrigerant as the main source of compressor heat
removal, so if the compressors are located in a tight area supplemental
cooling is required especially in tropical climates. Frigoboat has now
added a small heat sink to compressors connected to their keel cooler
compressors but I don't think it is large enough to do any good in
the tropics.

Dick

 
Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules

Smilies are On
[IMG] code is Off
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
I'm ba aaaack! jlr ASA 191 March 2nd 06 09:03 PM
Keel bolt material pete Boat Building 7 February 16th 06 09:53 PM
Any thoughts onhow to make this boat better [email protected] ASA 82 January 24th 06 04:16 AM
Robbie's false PHRF rating! Too low! Bob Crantz ASA 6 November 15th 05 12:10 AM
where2 get cheap sounding lead ? Courtney Thomas Cruising 34 October 19th 05 08:02 PM


All times are GMT +1. The time now is 01:08 PM.

Powered by vBulletin® Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Copyright ©2004-2025 BoatBanter.com.
The comments are property of their posters.
 

About Us

"It's about Boats"

 

Copyright © 2017