Home |
Search |
Today's Posts |
#1
posted to rec.boats.building
|
|||
|
|||
recommendations for alum. mast refinish ?
I don't know how the previous coating was applied nor what was used.
1-HOW2 prepare ? 2-Must it be taken back to bare metal for durable results ? 3-Easiest and least expensive [mutually exclusive ?] method of old material removal ? 4-Primed, and if yes, with what ? 5-Finished with what ? 6-Sprayed or brushed, and with what ? 7-Preferred source of coating and cost ? 8-Additional source of information ? Most gratefully, Courtney |
#2
posted to rec.boats.building
|
|||
|
|||
recommendations for alum. mast refinish ?
Courtney Thomas wrote:
I don't know how the previous coating was applied nor what was used. 1-HOW2 prepare ? 2-Must it be taken back to bare metal for durable results ? 3-Easiest and least expensive [mutually exclusive ?] method of old material removal ? 4-Primed, and if yes, with what ? 5-Finished with what ? 6-Sprayed or brushed, and with what ? 7-Preferred source of coating and cost ? 8-Additional source of information ? Most gratefully, Courtney ---------------------------- most certainly a moisture cured urethane - aluminum pigmented most likely. - also ideal for boat trailers, etc. no primer needed (the MCU is actually considered a primer too). - easy brush on application. cost under $40 paul oman progressive epoxy polymers ---------------------------- |
#3
posted to rec.boats.building
|
|||
|
|||
recommendations for alum. mast refinish ?
And to see if the old and new paints are compatible, place a rag wetted with
the solvent to be used with the new paint onto an area of the old paint, and if it lifts the old paint the two are not compatible, if it doesn't you can prep and paint over the old paint. MMC "Paul Oman" wrote in message ink.net... Courtney Thomas wrote: I don't know how the previous coating was applied nor what was used. 1-HOW2 prepare ? 2-Must it be taken back to bare metal for durable results ? 3-Easiest and least expensive [mutually exclusive ?] method of old material removal ? 4-Primed, and if yes, with what ? 5-Finished with what ? 6-Sprayed or brushed, and with what ? 7-Preferred source of coating and cost ? 8-Additional source of information ? Most gratefully, Courtney ---------------------------- most certainly a moisture cured urethane - aluminum pigmented most likely. - also ideal for boat trailers, etc. no primer needed (the MCU is actually considered a primer too). - easy brush on application. cost under $40 paul oman progressive epoxy polymers ---------------------------- |
Reply |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
Hobie 16 Mast | ASA | |||
Mast rebuild\hardware questions | Cruising | |||
Foam-filled mast | Boat Building | |||
Mast Repair | Cruising |