Home |
Search |
Today's Posts |
#5
|
|||
|
|||
Which Tool for Relieving Bulkhead ?
I know nothing about router blades. Ignoring the possibility of a router
blade, you can get a consitent depth of recess by first scoring the area to be recessed with a saw set to the depth of recess you want. Perhaps run a hand held circular saw along a line parallel to the edge of the bulkhead and then run a few cuts between this first cut and th edge. If the depth to be removed is only 1/8" there will be no problem following a curved line with a hand held circular saw set at that depth. Then take a power sander and sand down until the saw cuts just disappear. If working with plywood its pretty easy just to sand off the face ply. Its obvious when you start sanding into the second ply. If the face ply is the depth you want to remove, you're laughing my son. -- ------------------------------------------------------------------------------ William R Watt National Capital FreeNet Ottawa's free community network homepage: www.ncf.ca/~ag384/top.htm warning: non-freenet email must have "notspam" in subject or it's returned |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
Timing Volvo Penta 4.3 - Need "Special Tool"? | General | |||
[ANN] Tide Tool Freeware for Palm OS Updated | General | |||
Great memory tool for Cardinal buoys | General |