Fancy seeing you in this thread Khun Ken : ) I lurk here, but have
not posted much.

Somchai

Good to see your post K' Somchai,
Are you boat building or repairing anything interesting at the moment ?

Pohp kghan mai.
....Ken

"Flyingmonk" wrote in message
ups.com...
Fancy seeing you in this thread Khun Ken : ) I lurk here, but have
not posted much.

Somchai

For more penetration, heat kerosene or lamp oil in a double pan, and
grate a moderate amount of candle wax into it.
Too much, and it will precipitate out again when cooled.
A slight sludgy effect is what I like.

Brian Whatcott Altus OK

On Tue, 08 Nov 2005 13:39:20 GMT, "Roger Derby"
wrote:

Amen!

For cast iron (and any bare steel) versus rust, I slather on furniture paste
wax. Where it matters, I wipe it down to a thin coat and polish. It
prevents most rust and doesn't seem to transfer to the wood. Warm iron is
better -- it penetrates the pores.

The only gotcha is that I usually wait until after the first coat of rust
and then have to clean that off before waxing.

Roger (The only tools that get close to 50 hours per year are the cordless
drills and the sanders.)

http://home.earthlink.net/~derbyrm

"Denis Marier" wrote in message
...

I would like to add that most of the time these tools are not used.
During
the course of one year most hobbyists will use their power and hand tool
an
average of 50 to 200 hours.
The biggest problem with the cast iron machinery's is to remove the rust
from the surface table.
As for the Delta 12½" planer I have one. Last year it was completely
refurbished under legal warranty. Delta paid the total cost. They
advised
that this planer was designed for finishing work. With the amount of work
I
do (about 300 to 600 4/4 board foot per year) they advised me that I would
be better served with a bigger machine.

"Roger Derby" wrote in message
ink.net...
When I have no clue as to what constitutes a "good" tool, I buy the
cheapest, or sometimes the cheapest per pound. After I've figured out
what
it won't do, and what features I really hate, then I go looking for a
better
one. Many times I find that the cheapest does 90% of what I want and all
of
what I really need. Pride of ownership is a factor only you can judge,
but
I often don't use my Starrett square for fear of damaging it. The old
Sears
Dunlop isn't that far out of square.

If you're in a money making business with tool depreciation and labor
costs
as significant accounting factors, then my approach isn't proper.

I'm quite happy with my Craftsman 12" bandsaw. It's quiet and quite user
friendly. No, it will not rip straight lines without a lot of windage,
some
of which is user skill and blade sharpening, but my wife isn't afraid of
it
and it will whack a cardboard box or plastic milk jug down to size in
moments.

I've also gotten a lot of mileage from my Delta 12½" planer and have no
plans to replace it.

Just another view.

Roger

http://home.earthlink.net/~derbyrm

"seawitch" wrote in message
ups.com...
can any one help me which planer and a bandsaw would be a good buy
without overkill , but have a good tool.So many out there and i sure
can use some good advice.I have an idea but before write a ck, it would
be good to hear some of your input...