Need a 12 VDC potable water pump that puts out 125-150 psi at about 1
gal per min - this is low usage so cheap is good. Any suggestions.

This may be more than you need but look at a Pumptec T112. 2 GPM @
250PSI. Street price is about $170. With about $35 in stainless
fittings, hose and a couple of #3 15º pressure washer nozzles and you
have an anchor washdown system that will blow off the stickiest oyster
bank mud.

http://www.pumptec.com/AgCatalogPage...Ag_03_2002_pg4

Don't use it for domestic water though. It will blow out every hose on
the boat. :-)

yes wrote:

Need a 12 VDC potable water pump that puts out 125-150 psi at about 1
gal per min - this is low usage so cheap is good. Any suggestions.

--
Glenn Ashmore

I'm building a 45' cutter in strip/composite. Watch my progress (or lack
there of) at: http://www.rutuonline.com
Shameless Commercial Division: http://www.spade-anchor-us.com

Hi,
Usually these type of pumps are set at about 40 pounds and
3-4 gals per min

I use flojet and have had very good service from them and
they supply plenty of water for about 4 outlets at the same time.
This is usually plenty on a boat up to about 50foot. If you
want to save water you can buy the very fine spray shower roses.

Cheers
Oliver Fleming


"yes" wrote in message
...
Need a 12 VDC potable water pump that puts out 125-150 psi at
about 1
gal per min - this is low usage so cheap is good. Any
suggestions.