Home |
Search |
Today's Posts |
#1
|
|||
|
|||
epoxy does so pass water
The owner of an epoxy sheathed plywood (okume marine) kayak was showing me
today the deterioration in the surface ply on the inside of the hull. The builder had let the boat sit outside over the winter mistakenly assuming epoxy was impervious to H2O. Snow accumulated in the cockpit, melted, froze, melted again, and by late spring there was 6" of melt water inside the hull. The epoxy sheathing on the inside of the hull did not stop the water from getting at the plywood and starting rot. Accept the claims of epoxy purveyors and promoters at your peril. -- ------------------------------------------------------------------------------ William R Watt National Capital FreeNet Ottawa's free community network homepage: www.ncf.ca/~ag384/top.htm warning: non-freenet email must have "notspam" in subject or it's returned |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
HELP! Water in bilge when running... | General | |||
Habbi's gearcase full of water | General | |||
Where to find ramp stories? | General | |||
Trailer Tires Overheating. | General | |||
Hooking up flush muffs...no water coming out of discharge (outboard) | General |