surfnturf wrote:

Never did any prep except killing the ignition. Gas lines, tank (with closed
vent) and carb left full without snake oil. No problems at all, never had to
clean carb. Just trailer to the water, then fire her up. Runs good after 10
years.

Perhaps cooler Canadian weather helps, but I suspect real problem may be
allowing gas to evaporate.

IMHOP

By George, I think you hit a nail, there surfnturf! Keep vents
closed for storage.


"Ed Edelenbos" wrote in message
...

Terry Spragg wrote:


I never again drained the fuel system, just add stabilizer, fill
the tank, turn off the fuel pump and run it till it quits.


Key phrase there... fill the tank. And, all parts (pump, carb bowl,
lines, etc.) should be emptied (i.e. running the engine with the fuel
source shut off is the easiest wat to get most of hte gas out.


I don't believe all this talk about 'bad gas', except for that
anecdote, and wonder how climatic zone recipies and storage
parameters could affect this.


A partially filled tank and gas in the lines is a recipe for trouble
(imo).

My lawn mower gets gas from overwinter and has never balked,
either. I just fill it up and stop it. Maybe Canadian gas is
better, somehow?


I use old gas in my mower also. I've used it (50% mixed with fresh gas)
in my car. I can't remember it balking but... there has never been a
risk of having to paddle my mower (or car) back to shore. $100 worth of
gas isn't worth the risk in my book.

Ed


--
Terry K - My email address is MY PROPERTY, and is protected by
copyright legislation. Permission to reproduce it is
specifically denied for mass mailing and unrequested
solicitations. Reproduction or conveyance for any unauthorised
purpose is THEFT and PLAGIARISM. Abuse is Invasion of privacy
and harassment. Abusers may be prosecuted. -This notice footer
released to public domain. Spamspoof salad by spamchock -
SofDevCo