Home |
Search |
Today's Posts |
#1
|
|||
|
|||
Evinrude 6HP Water pump replacement
I have an older Evinrude 6Hp outboard model number 6602EE09200...i
think it is a 1966 model. I am trying to replace the waterpump as it has stopped pumping water. When I remove the 4 bolts holding the foot on, it doesn't pull off the lower unit. Is there something else I have to release in order to remove the foot and get to the water pump? Any advce would be appreciated. Doug and Patty |
#2
|
|||
|
|||
D&P
I don't remember specific models any more, but does it have a shift ? If it does, look for and open the little door about half way done the port side of the leg and take one of the screws out of the shift rod coupling. Some models also had a 5th screw at the front of the casing. If it is sort of loose but won't separate at all, that is usually the rubber bushings for the water tube that have adhered to the tube. This can be a bear if the top one tears when you pull it apart. I hope something here is a help. Good luck Matt Colie wrote: I have an older Evinrude 6Hp outboard model number 6602EE09200...i think it is a 1966 model. I am trying to replace the waterpump as it has stopped pumping water. When I remove the 4 bolts holding the foot on, it doesn't pull off the lower unit. Is there something else I have to release in order to remove the foot and get to the water pump? Any advce would be appreciated. Doug and Patty |
#3
|
|||
|
|||
Also look for a bolt under the cavitation plate at the prop end. You might
have to remove the trim tab, if it has one, to get at it. "Matt Colie" wrote in message ... D&P I don't remember specific models any more, but does it have a shift ? If it does, look for and open the little door about half way done the port side of the leg and take one of the screws out of the shift rod coupling. Some models also had a 5th screw at the front of the casing. If it is sort of loose but won't separate at all, that is usually the rubber bushings for the water tube that have adhered to the tube. This can be a bear if the top one tears when you pull it apart. I hope something here is a help. Good luck Matt Colie wrote: I have an older Evinrude 6Hp outboard model number 6602EE09200...i think it is a 1966 model. I am trying to replace the waterpump as it has stopped pumping water. When I remove the 4 bolts holding the foot on, it doesn't pull off the lower unit. Is there something else I have to release in order to remove the foot and get to the water pump? Any advce would be appreciated. Doug and Patty |
Reply |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
rec.boats.paddle sea kayaking FAQ | General | |||
rec.boats.paddle sea kayaking FAQ | General | |||
The future of yacht design - 10 myths scotched | ASA | |||
Water systems on my boat - need suggestions, please. | Cruising | |||
rec.boats.paddle sea kayaking FAQ | General |