I'm building a plywood (4mm Okume) kayak. I'd like to cover it with a
fabric; Dynel, polypropylene, or Xynole Polyester. I have the Defender
catalog but can't tell from the descriptions of these fabrics which
would be the best solution. I need a small amount so cost is not a
consideration. I'm using West epoxy. Any suggestions???

Thanks
Dick

On Fri, 15 Oct 2004 12:25:00 UTC, Dick Robertson
wrote:

I'm building a plywood (4mm Okume) kayak. I'd like to cover it with a
fabric;

What's wrong with fiberglass..??

--
steen - menzi.dk
Ready for OpenOffice?
---

"steen" wrote in message
...
On Fri, 15 Oct 2004 12:25:00 UTC, Dick Robertson
wrote:

I'm building a plywood (4mm Okume) kayak. I'd like to cover it with a
fabric;




Hello I have used all kinds of fabric with Expoxy had very good results
with denim . Higher weights harder to wet out.
I find fabric as opposed to glass easier to mold around corners curves etc.

Rey

Reynaud wrote:
"steen" wrote in message
...

On Fri, 15 Oct 2004 12:25:00 UTC, Dick Robertson
wrote:


I'm building a plywood (4mm Okume) kayak. I'd like to cover it with a
fabric;




Hello I have used all kinds of fabric with Expoxy had very good results
with denim . Higher weights harder to wet out.

I find fabric as opposed to glass easier to mold around corners curves etc.

OK, but you sacrifice strength and abrasion resistance. What's your
goal? Durability? Aesthetics? Something else?

Dick Robertson wrote:
I'm building a plywood (4mm Okume) kayak. I'd like to cover it with a
fabric; Dynel, polypropylene, or Xynole Polyester. I have the Defender
catalog but can't tell from the descriptions of these fabrics which
would be the best solution. I need a small amount so cost is not a
consideration. I'm using West epoxy. Any suggestions???

Why are you considering these fabrics as opposed to fiberglass? Dynel is
very abrasion resistant, but that's it's major claim to fame. I have no
experience with the other fabrics, other than that I know they will not
wet out clear like fiberglass does.

On Sat, 16 Oct 2004 14:16:07 UTC, Brian Nystrom
wrote:

wet out clear like fiberglass does.

Silk might, though. Know it's been used for a surfboard in some kind
of special project.

--
steen - menzi.dk
Ready for OpenOffice?
---

steen wrote:

On Sat, 16 Oct 2004 14:16:07 UTC, Brian Nystrom
wrote:


wet out clear like fiberglass does.


Silk might, though. Know it's been used for a surfboard in some kind
of special project.

OK, but what's the point? What properties does silk offer that are
superior to fiberglass on a kayak hull?

On Sun, 17 Oct 2004 14:18:41 UTC, Brian Nystrom
wrote:

Silk might, though. Know it's been used for a surfboard in some kind
of special project.

OK, but what's the point? What properties does silk offer that are
superior to fiberglass on a kayak hull?

None I know of, but the guy were looking for alternative cloth
materials. Thickness = weight must end up lower, than with fiberglass.
Think this was one of the goal for that surfboard project.

--
steen - menzi.dk
Ready for OpenOffice?
---