About Us

I am Tosk

In article ,
says...

Bruce wrote:

I just went through a fairly extensive blister repair and basically if
you use epoxy and fill gouges with chopped mat and epoxy the repair
will likely be stronger then the original hull, assuming that the hull
is polyester. Feather the gouge out and pack it with epoxy saturated
mat. If you are worried about osmosis, after you have made your
repairs grind the entire underwater area down to a good solid surface
and roll on two coats of epoxy. Put the first coat on and let it set
up until it isn't sticky but you can still mark it with your finger
and then roll on the second coat. After the second coat sets up, but
still not hard, roll on a coat of epoxy high build primer and leave it
for a day or so.

If you don't wait long enough after the first coat of epoxy the second
coat will be very heavy as you have to slop it onto a sticky surface
and if you paint the primer too soon it will craze - tiny cracks all
over the place. The reason for all this hoopdi-do is that if you let
the usual epoxy set hard it will have an oily film on it called "amine
blush" and then you have to wash the whole thing clean, let it dry,
wipe it with thinner, and repaint.

Finish sand and two coats of two part polyurethane. You'll be good
for ten years or so.... However it is more costly then polyester and
barn paint.

Cheers,

Bruce

I gotta say, Bruce, about the only thing that could be done beyond that
it a couple of layers of new glass over the entire underwater hull.
A close out layer that seals off all the possible cracks and crevasses from
water incursion.

Not that such would be economically feasible...

Richard

Nor would I ever add that much weight to a proven design... Couldn't all
that weight make it sit differently in the water and effect it's
efficiency and safety?

Scotty

--
For a great time, go here first... http://tinyurl.com/ygqxs5v

Thread Tools	Search this Thread
Show Printable Version	Search this Thread: Advanced Search
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
checking the hull's integrity...	Tim	General	12	March 24th 10 07:16 PM
Checking in	Ron Wilson	Cruising	9	February 21st 09 07:48 AM
INTEGRITY CAN MAKE YOU EASY MONEY!!	[email protected]	General	10	February 5th 08 02:58 AM
Just checking	Tom G	General	2	May 3rd 06 01:27 AM
Checking In	Michael	ASA	31	June 8th 04 11:29 PM

Menu

About Us