Similar
boats. Similar prices. Indistinguishable from a distance of 25 miles.

I guess everyone here would agree that the Euro-styled Beneteau's look
JUST like the Catalina's!!!?
Okay...from 25 miles away....nope. I can still tell the difference.

RB
35s5
NY

Capt. Rob wrote:
Similar

boats. Similar prices. Indistinguishable from a distance of 25 miles.


I guess everyone here would agree that the Euro-styled Beneteau's look
JUST like the Catalina's!!!?
Okay...from 25 miles away....nope. I can still tell the difference.

RB
35s5
NY

I see Beneteau recalled the furler on the first few years of 35s5. It
seems it was the Isofurl. Has yours been changed?


http://hisse-et-oh.com/forum/index.p...a62110d585e5ba

Sorry if you can't read French.

Basically, if you have an 88, 89 or maybe a 90 35s5 or a 98 or 99 35s5,
contact Beneteau.

Gaz

I see Beneteau recalled the furler on the first few years of 35s5. It
seems it was the Isofurl. Has yours been changed?

Another great reason to buy a boat from an active builder. Gave
Beneteau the hull number and they reported all warranty work done,
including the furler changout in 1996.

RB
35s5
NY

Capt. Rob wrote:
I see Beneteau recalled the furler on the first few years of 35s5. It
seems it was the Isofurl. Has yours been changed?

Another great reason to buy a boat from an active builder. Gave
Beneteau the hull number and they reported all warranty work done,
including the furler changout in 1996.

RB
35s5
NY

That is nice.

OK, Y'all, here's the physics. The fiberglass fibers would be nearly
clear if they were not small enough to scatter light. Imbedding them
in a matrix of resin that has an index of refraction close to that of
the glass reduces the scatter and makes it seem more transparent.
"Opaqueness" of some hulls is most likely due to excessive scatter from
impefections in the resin. Thus, you might expect a very well built
hull to be nearly transparent except for some tinting due to absorption
of color.
This makes me wonder if it might be possible to make a hull bottom
nearly transparent.

As the numbers of resin/glass interfaces goes up, the scatter goes up
because of the slight diff in index of refraction between glass and
resin. I wonder if proper choice of glass or resin (so as to match
indices of refraction) could make a transparent (rather than
translucent) hull.

Wonder no more

http://australiavideo.com/cairns/gre...lassbottom.JPG