I'm about to pick up a new depthsounder for the C&C 32 and the Standard Horizon
DS45 is on the list. They also sell an in-hull puck type transducer. Sounds
like more fun that fighting to get the old one out.
The C&C 32 is solid glass below the waterline. What will I lose in terms of
performance vs. traditional thru-hull. Any loss in acuracy?


Thanks,

Robert B
C&C 32
NY

On the Nonsuch I glued the cheap transom mount transducer for an Apelco 260
inside the hull. I didn't think there was much loss of sensitivity - I got
soundings down to 200 feet, and always had a clear picture. I liked it so much
I requested the 262 for the PDQ. They used the standard through-hull mount
towards the bow, and frankly, its not as good. Its so sensitive I have trouble
when following powerboats.

Fortunately, however, since the 262 (now RayMarine) is a FishFinder, even when
the signal gets garbled its easy to tell what's going one. If your simple
sounder hits some bubbles from a wake all you see is a "4 Feet" reading, with no
indication of what's going on.

"Bobsprit" wrote in message
...
I'm about to pick up a new depthsounder for the C&C 32 and the Standard
Horizon
DS45 is on the list. They also sell an in-hull puck type transducer. Sounds
like more fun that fighting to get the old one out.
The C&C 32 is solid glass below the waterline. What will I lose in terms of
performance vs. traditional thru-hull. Any loss in acuracy?


Thanks,

Robert B
C&C 32
NY

Hey Nutsy,

I have two finders on my boat; A thru hull digital and a hummingbird
graphic epoxyed to the hull.

The hummingbird is my perferred unit. I really don't think I've lost
zip.

The Graphic is mounted at the Nav Station on the inside and the digital
is cockpit mounted. When I go to look for bottom info, I shift to the
inside helm so I can read the bottom

Ole Thom