Home |
Search |
Today's Posts |
#19
![]() |
|||
|
|||
![]()
interspersed ...
"otnmbrd" wrote in message ink.net... .... A simple test, would be both engines astern, equally. Since they are both "left hand", your boat should immediately start backing to stbd. How quickly and at what "turn rate", would indicate the degree of prop walk. I'm guessing here, but I'm betting you can steer your boat astern by just increasing/decreasing throttle on one or the other of the engines? I don't recall the boat ever doing anything other then going straight back as it first started up. Yes, I back down a long narrow fairway with throttle alone, rudders centered. Thus, the net affect is zero propwalk, but I have no way to determine whether the individual engines are generating propwalk. Another way would be back on port engine and get a sense of "turn rate", then back on stbd and compare (backing on stbd, could/should produce a slower turn rate) Yes, I should try that, if only to get an answer to this question. BTW, the builder claimed this was a non-issue, but when they started building larger sailing cats, and the powercat, they used counter-rotating props, because it was an option with the larger transmissions. Your transmission/reverse gear is only built to turn in one direction? Can't be built to turn opposite? No, obviously there is a reverse, but many transmissions favor one direction amd the other is only for intermittant use. There are differences in the gearing and the lubrication. Other transmissions can be set up either way. I don't know what the issue is with the small Volvo and Yanmar saildrives but the only props they (Volvo) make for them are LH - I take that as a sign. There is an often talked about case of a trawler that was setup counter rotating by running one tranny in reverse. It took them a while to figure out why that transmission always cooked in a few hundred hours. Overall, I'm guessing that the spacing of your props, andG as mooron says, the fact you have folding props of relatively little "bollard pull" means that for most maneuvers you do, prop walk will be there, but not of enough significance, when compared to the reaction of your boat to the spacing and thrust of your props, so, as the builders claim, it will generally be a non issue. maybe so, maybe so. otn |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Forum | |||
Beautiful day on the Bay | General | |||
FS: Beautiful 43' Garden Sailing Ketch in Oxford, Md. | Marketplace | |||
Another Beautiful Bay Day! | General | |||
Beautiful day on the Bay - again! (Repost) | General | |||
FS: Beautiful 43' Garden Ketch in Oxford MD. | Marketplace |