I've come to the point of cutting. I'll not go back with a bearing unless
forced to do so; my analysis and comparison of the prior installation (when
we bought the boat) strongly suggests that when I fix what I presume to be
the problem (excessive length beyond the cutlass, exacerbated by a dinged
prop), the earlier referenced self foot-shooting, the whip will disappear.
I'll be going quite a bit further than the previous installation in removing
excess length beyond the cutlass, so much the better (methinks, anyway).
And, I'd thought to do the opposed cuts, too. That way, should I succeed in
snapping it open on the top with a chisel or other splitter, the halves
would have room to move (making it easier to split/deform) toward each other
on the bottom.
Thanks, all. Pix to follow. Current debate internally is about dremel or
grinder, both of which I have aboard. Seems to me, with the horses
available, that a dremel would take figuratively forever, but, OTOH, might
have lesser possibilities for shaft impingement ($2 word meaning cut!) due
to slower progress and lighter weight presuming better control. Maybe both,
with the gross cutting done with the grinder...
Hmmm. Thinking about it, I believe that the dremel wheels might not be deep
enough to penetrate all the way. I'll have to see when I dig it out.
So, perhaps today, I'll have both of my vexing challenges settled, as I'll
also be EZ-outing my headless bolt...
L8R
Skip
--
Morgan 461 #2
SV Flying Pig KI4MPC
See our galleries at
www.justpickone.org/skip/gallery !
Follow us at
http://groups.yahoo.com/group/TheFlyingPigLog
and/or
http://groups.google.com/group/flyingpiglog
When a man comes to like a sea life, he is not fit to live on land.
- Dr. Samuel Johnson