Perkins 4.108 deisel
			 
			 
			
		
		
		
			
			Larry wrote: 
 Bruce in Bangkok  wrote in  
 : 
  
 On Fri, 25 Jun 2010 18:35:45 -0700 (PDT), jayhearts 
  wrote: 
 
 Greetings, 
 
     We've moved up from a Tartan 30 with an Atomic Four to a Gulfstar 
 41 CC Aux Ketch with long range cruising plans and a Perkins 4.108 
 deisel engine.  In the Atomic Four world there is a vibrant 
 aftermarket of parts and knowledge.  Does anyone know if there is a 
 similar source of information, parts and advice for our new old 
 engine?  We Homeport in the lower Hudson Valley, New York.  Thanks for 
 any advice, also welcome connection to other Gulfstar and or Ketch 
 owners. 
 
 Thanks, 
 J 
 The Perkins 4-108 was common as dirt in its day and there should be no 
 lack of parts even today. Some years ago I had occasion to overhaul a 
 4-107, the model that preceded the 4-108 and while it took a couple of 
 days looking I found a stock of parts for that old engine. You should 
 have no problem. 
 
 Just as a warning. Perkins warns against using either or  other 
 "starting fluids" in these engines. I disregarded their warning which 
 the result that  a pre-combustion chamber was blown out of the head 
 and into the cylinder damaging both the head and a piston and liner. 
 Thus the overhaul I mentioned above. 
 
 Cheers, 
 
 Bruce 
 (bruceinbangkokatgmaildotcom) 
 
  
 We got a 4-108, complete with even the wires and panel and a good  
 transmission for $1500 in NC.  The guy swapped it out for a Yanmar  
 because his marina had a Yanmar dealer in it.  The 4-108 ran perfectly,  
 but we had to swap the transmission to the old one that's made to  
 freewheel so we could use our shaft alternator to charge the batteries  
 under sail.  25 amps is worth the effort.  Unless it's below freezing, I  
 cannot imagine having to preheat or use starting fluids on a Perky 4- 
 108.  Something is wrong with one that won't start in summer at the  
 first touch.   It might have low compression from bad valves or worn  
 rings or something wrong with the injection system.  We've never  
 preheated or sprayed fluid into even the old one that had tens of  
 thousands of hours on it because the boat's previous owner thought it  
 was a trawler with a tall antenna mast instead of a ketch. 
  
 I thought I had the parts, service and overhaul manuals for it,  
 somewhere on one of these drives, but my search for this thread only  
 found the 4-154, Ford Lehman and Velvet drive manuals if anyone wants  
 them in Zipped up PDF format.  I can't find the 4-108 manuals anywhere  
 here.  Cap'n Geoffrey has them on his laptop as I put them there and may  
 have erased them at home....which would be unusual. 
  
  
  
Hi, Larry, I'd sure like a copy of the 4-154 manual. 
 
Email is my_first_name at wind-angel.com. 
 
Thanks, 
Jim. 
		 
		
		
		
		
		
		
		
		
	
	 |