"katy" wrote in message
om...
Edgar wrote:
"katy" wrote in message
om...
Yeah..we havwe to do that sometime in March...have to go down to
Oriental to do it since we draft too deep for the boatyards here and
have been stuck in the mud there once before..and we weren't too pleased
with them anyway...we'vew been having the divers scrape the bottom
seasonaly and it's pretty clean and they replaced one zinc last time but
we need the stuffing box repacked and stuff like that (and no, Doug...I
do not want to do that in the water...not that I have no faith in you
guys but...)

go on Katy, try it afloat. It will not sink your boat.
First check that you have the right sized square section packing. Measure
the shaft diameter and the diameter of the stern tube's housing for it.
Both these things can be done before you loosen anything off.
Subtract the shaft diameter from the other one and divide by two. This
gives you the size of the packing you need. Obtain a length of the
correct section packing
Then wrap the packing around the shaft and with something really sharp
like a Stanley knife cut through both parts of the packing so you have a
turn of packing that just fits the shaft when the two ends butt together.
Make about four of these and you are set to go.
Slide the packing gland compressor piece out along the shaft and with
something sharp pointed pick out and remove the first turn of packing.
There are probably three turns in all so you can also remove the second.
Very little water should be coming in as yet and unless you feel brave
enough to take the last one out as well you can just replace the two you
have taken out-staggering the joints- and these two new packings will
seal the gland again. The last one can be left in situ until your next
haulout.
The secret of success for this job is to have the right size of packing
already cut to exact size before you dismantle anything. You cannot do a
decent job of cutting packing to length when water is coming in all
around the job, but the actual quantity of water coming in with no
packing at all in place is not going to sink your boat if you are ready
with the right size pieces of packing to put back in.
You are able to do this because you have a traditional stuffing box. Mine
is a 'dripless' system with a carbon seal running on a polished face and
to replace it I would not only have to haul out but also would need to
pull the shaft right out.
nononono..you guys don't understand...they know HOW to do it...it's the
mess they create when they do it and I ahve to clean it up...you have to
access through the aft cabin and tear out al the bedding etc...in a 31 ft
boat there is just bnot tahat much room when you're living on it...


It's not much of a mess... the bilge pump will take care of it. I did it on
my 30 ft, no problem. The bilge pump ran twice for a couple of minutes.


--
"j" ganz @@
www.sailnow.com