On Sun, 27 Jun 2004 08:46:27 -0400, Jonathan
wrote:

I've laid out the various parts on sheets of okoume (the designer
supplied very tight layout schematic, with sometimes barely two saw
blade widths between parts) and will begin cutting the pieces free later
today.

I have both wire and cable ties on hand, and will see how each works and
then use them as i need them.
Do one side with cable ties and the other with copper and let us know
which is easier.

As one panel has to be duplicated, I have decided to cut it out once,
then copy the pieces to the other panel. I then plan to clamp the two
identical pieces together and sand them so they are *exactly duplicate.

Sand the first one to exactly where you want it and cut the second and
third ones with a pattern bit in the router.
I would purchase another sheet of okoume anyway because I will
certainly screw up something. I always manage to. :-)

Good Luck,
Dan
I plan to leave the lines when cutting. When they are clamped together I
will then sand the package back to the line on the first piece. It has
been my experience when tracing that the second piece winds up a little
bit bigger than the original. If one were to take a third copy off the
second piece, the difference between the first and third would be
noticeable.

I would appreciate anyone sharing any first time goofs that they can
remember (and bear to share).

This is a link to a wooden boat I did extensive repairs to a few years
ago, a Carl Alberg design built by Graves in Marblehead, MA.

http://www.alberg30.org/CarlAlberg/WoodenBoats/Alestra/

Thanks,

Jonathan