Super power magnet like in the cartoons?

Two analogies, arrows and splinters.

Arrows: Grind off the heads, pull the ribs free one at a time and drive the
nails through.

Splinters: Whatever will do the least amount of tissue damage around the
nail. Given that the wood's strength is lengthwise, get at the nail from
the sides where it has already cut the grain with needle nose pliers.


"Karin Conover-Lewis" wrote in message
...
I have to wonder whether it wouldn't be feasible to drill out the current
rusted nails with a plug-cutter, glue plugs into place, then refasten --
offsetting the original holes slightly. Another idea (again, I don't know
how feasible) would be to drill out the rusted nails and then refasten in
the same hole, but using trunnels instead of nails or screws.

--
Karin Conover-Lewis
Fair and Balanced since 1959
klc dot lewis at centurytel dot net


"Steve Lusardi" wrote in message
...
I have noticed that no one else has responded to your query. I think you
know the answer already. There is no practical way to remove all the
nails
without destoying all the planking. You have to ask yourself if you want
to
replank the hull or if you want to sell it to some one else who will,
because replanking is the only solution. Be advised that if common steel
nails were used in the planking, they probably were used elsewhere as
well.
Steve
"Jess" wrote in message
om...
Can anyone advise me on treating my nail-sick strip-planked boat?

She is iroko on steamed oak beams. The planks have been fastened both
transversely and into the beams with ferrous nails (I think they are
steel). These are now apparently rusting, and pushing out the wooden
pellets filling the counter-sinking above the nail-heads. A few have
popped completely, many are just forcing the pellets up proud of the
outside surface of the hull.

Perhaps because this has been a long-standing problem, a previous
owner has epoxy-sheathed the whole vessel. Clearly it hasn't fixed the
problem.

How is this best treated?
Should I remove the pellets and treat the nails? What would I treat
them with?
Can I replace the nails in any way?
How would I make good the epoxy coating? Can I just patch it with
epoxy after making my repairs, or will this ruin its integrity?

Any thoughts would be really welcome.

Thanks,
Jess