I am not a boat builder. I have built a kayak though and am an avid
woodworker. Have you thaought of buying lumber in the lenghth you need
then cutting it into veneers? If you do this you could make the veneers
as thin or thick as you wish and then jaminate them to your plywood
stock which has been scarfed.

Mindprobe wrote:
Is anybody familiar with this product? anybody using it/have used it
for boatbuilding? Finally, where to find 8 ft. and larger plywood for
boatbuilding (A/C ok, but prefer marine grade) in the Atlanta area?

Finally, I'm not real technical, so I'm looking for simple,
easy-to-use Boat design software that can help me develop flat panels
for plywood construction from simple hull shapes. Any suggestions?

Thanks in advance!