View Single Post
  #4   Report Post  
posted to rec.boats
frank1492 frank1492 is offline
external usenet poster
 
First recorded activity by BoatBanter: Jul 2006
Posts: 31
Default Emergency Oil Pan Repair Needed

It is a pinhole opening I am sure but the surrounding metal is shot
over a space the size of a quarter or larger. I had thought of using a
screw with a rubber washer, but since the surrounding metal is in such
poor condition, I was afraid the screw might pop out sending a stream
of hot oil with it until I lost all 5 quarts in the bilge!
I think I will go with the JB weld/ Marinetex idea plus
fiberglass as Ed suggested. Or maybe a screw first? Or screws later to
secure the patch (all in sound metal.) Or a brace against the pan over
the patch.
Thanks all. I think I know what to try. Will let you know.
Frank











On Sat, 30 Jun 2007 20:34:18 -0400, Ed wrote:

The screw sounds easy!!! Use a rubber washer as well.
If is it larger, I have had luck with Marinetex. The key is CLEAN
oiless sanded work space... Cover with marinetex about 4 times the size
of the patch area... cover with fiberglass mat, cover with more
marinetex. JB weld can also work. Again.. patch it once with the
chemical, cover with with glass matt and recover with more chemical.



Jim wrote:
If it's a pinhole, put a screw in it.
"frank1492" wrote in message
...

I have an '88 Grady White with a 4.3L OMC Cobra (I believe
this is a Chevy Engine- 6 cyl.) The pan has developed a leak
right on time for the holidays and I have no chance of getting
it replaced now.
The hole area appears to be at the end of the engine facing
aft and is accessable. I am tempted to drain all the oil out, sand
the area well and try a fiberglass patch. Any chance this will
work?
Or how about JB weld?
Thanks. Frank.