Thank you for the advise.
That said, the photos are 1015Kilobytes not 650 MegaBytes...
I'm not fortunate enough to have a 25" monitor either.
Sorry for the problem. I'll use a web link in the future...

The problem is simple, the silly plastic piece is broken and I'm looking for
a replacement... It's from the '87 model so I'm probably just wasting time.

Dan


"Dan Krueger" wrote in message
ink.net...
FYI - Binaries (photos) are not allowed here. That said, you posted two
at
about 650 MB each. Those of us without 25" monitors couldn't see them
without
scrolling and even then they didn't give a clue to your problem.

Next time use a group like alt.binaries.fishing or post a link to them on
a web
page or even a free (Yahoo, etc.) photo site.

Dan


jojo wrote:
Here is a second photo that shows the jaw clamp attached to the rail
portion
of the part that I'm trying to replace. The upright pole attaches to
the
top of the jaw clamp and the jaw onto the rail, with a screw down to
tighten
the jaw and hold the upright pole in place.

Jo
"John H" wrote in message
...

On Sat, 19 Jun 2004 23:10:28 GMT, "jojo" wrote:


Our bayliner 17' cover had a rough trip and we broke the slide rail
off.
We have been looking for a replacement piece, but have found none the

same.

The bayliner is an '87 capri with cuddy.

The support pole has a jaw piece that grips the rail and then there is
a
screw to tighten the jaw on the rail for placement.

Any ideas? Would it be easier to just find some other hardware pieces

that

could work instead? Any suggestions on what type of hardware would be

good

to replace it with?

jo


Got a picture?

John H

On the 'Poco Loco' out of Deale, MD
on the beautiful Chesapeake Bay!