In article . com,
"Skip Gundlach" wrote:

I'm going to follow up to see if one *must* screw it back down (vs,
e.g., wedging i.e. are the screws necessary for structural integrity,
or just used to pull it tight?) to make it happen. If wedging will
suffice, likely we won't have to pull the tanks, minimizing an already
labor intensive project into something far more manageable.

I suspect it's like doing glue & nail in woodworking: The nails are
really there only to get a good bond; you could pull them after it's set
up. But you want a really good bond....

Agreement with KLC's assessment on the "cleanness" of the break. Rough
is better, polyester probably your best bet, fortified with something
strong that you can shoot in with, say, a caulk gun.

It does keep sounding better and better.

Just a thought that you might toss around: to get pressure on the
joints, you might intentionally put jackstands at those areas,
intentionally a bit too "tight"; the hull will probably flex outward
afterwards, pulling the bulkheads back in place.


--
Jere Lull
Xan-a-Deux ('73 Tanzer 28 #4 out of Tolchester, MD)
Xan's NEW Pages: http://web.mac.com/jerelull/iWeb/Xan/
Our BVI FAQs (290+ pics) http://homepage.mac.com/jerelull/BVI/