Peter,
I don't think that will be a problem for the display, most of them will
handle a low voltage condition
without a problem but a switching type will interfere with the radios. Plus
it is beyond a first time do it yourself project.
Captain Joe
On 15-Jan-2007, Peter Bennett wrote:
Actually a 60 watt load is a lot for a non switching regulator to do.
You don't want a switching type on a boat as it interferers with the
radios.
I think your best bet is :
http://www.nteinc.com/specs/900to999/pdf/nte933.pdf
I have used this in airplanes with good luck before.
NOTE! USE a BIG heat sink!! it will get hot. If it gets too hot the
device
will auto shutdown.
Captain Joe
The NTE933 is not a good choice for this application - the minimum
input/output differential (AKA dropout voltage) is 2.6 volts - on a
car or boat 12 volt system, this means that the NTE 993 regulator will
only be working as a voltage dropper, and not as a regulator.
I think that the only solution for the OP is a switching regulator
that can both buck and boost the input voltage.
--
Peter Bennett, VE7CEI
peterbb4 (at) interchange.ubc.ca
new newsgroup users info : http://vancouver-webpages.com/nnq
GPS and NMEA info: http://vancouver-webpages.com/peter
Vancouver Power Squadron: http://vancouver.powersquadron.ca