View Single Post
  #3   Report Post  
posted to rec.boats
 
Posts: n/a
Default Speedometer advice & starting problem

My speedo never really works, and when it does decide to budge, it's
never accurate.

The only thing I'm concerned about is the oil pressure, tach, and volt
meter...


oelf92 wrote:
PROBLEM 1: I have a 94 Chaparral w/ a 350MAG Mercruiser. I recently took
the outdrive off for servicing and after replacing the speedometer didn't
work. It is defintely connected What are the best ways to trouble shoot
this problem out of the water?

Also I previously posted the following: -----------
REOCURRING PROBLEM 2:
I have a 94' Mercruiser V8 350 engine in my boat (21' chaparral). For the
past year I have had some difficulty starting it. I dry dock it and when I
start it up on the hose in the beginning of the weekend to make sure
everything is working before taking it out, it's extremely difficult to
start, I usually have to put it in neutral and pump/push it forward and back
maybe 5 times then almost put the throttle all the way forward for it to
start (and still it has to crank for a about 5 seconds before it starts),
once started i run it at maybe 2000rpm for a minute or two then I can put it
back to idle and no problem. If I let it run for a while the next time i go
to start it, it turns over perfectly.... Now when I put it in the water an
hour or two later, i have the same problem except it is magnified and more
difficult to start.

As for the starting problem, i have tried pumping the throttle like 10-15
times before starting, but still takes forever....


THANKS FOR ANY HELP..