You might check with these folks
http://www.merequipment.com/index.html
I bought my Hurth transmission from them when I needed to replace a
bad one, and I was very pleased with my experience with these guys.
randy
On Mon, 12 Apr 2004 18:50:53 GMT, "Skip Gundlach"
wrote:
I'm looking for the plate which bolts to the tranny with 4 bolts with their
heads facing the engine, about 4" apart at the top and bottom pairs and
perhaps a little less in height (on the port and starboard height
separations), and to the bell housing with 6 bolts, 3 each on the starboard
and port sides, with their heads facing the stern.
It's circular, essentially flat (with some web bosses), about 11" in
diameter. There's also a couple of what look like potential bracket
mounting bosses on the top section (above where the tranny bolts to it, on
the outside, facing the tranny) of about 1/4 centers, about 4" apart. As
mine weren't used, they're not important, but might help identify the part.
Likely this mount was used in all Perkins 4-cylinder to Hurth trannies, but
I don't know that for certain, at all.
Anyone have one from a junk/pull, or know where I should look?
Thanks.
L8R
Skip and Lydia