What were you having done that took so long?
four or five patches, and the valves serviced, and a "take your time" from me

Did you never have a motor, or did the old motor bite the dust?
I have never used it, but it will be a dive boat
Good sized boat! Use it for diving?

has the "solid" aluminum interlocking floorboards, and the
max rating is 65 h.p., of course I'm sure that's WAY too much....any
ideas?

Can't make any recommendations without knowing how you use the boat and what
any prior experiences were.

At first glance, "bigger is better" tends to jump to mind on motor size. You
can always NOT open the throttle all the way, but if you don't have the
power you can't use it.

On the other hand, bigger is usually heavier, and the added weight can be an
issue. I assume that any size motor you would consider would push it beyond
the "clamp on" models and that you wouldn't be removing the motor on a
regular basis, but the weight balance in the boat might still be an issue.
Does this have a center console, or would you be tiller steering this beast?

If it tiller steered I might go with a smaller motor, just for ease in
steering and due to weight concerns at the stern. But then, the load you
expect the boat to carry might dictate a larger motor.

Have you used this boat before? If so, what size motor did it have on it?
I had an Achilles 14" w/ Tohatsu 40, plenty of power, but no longer available,
and would like the quiet of 4 stroke. It will be tiller steered, I like
simplicity, but It's hard to find a "big" motor, that is tiller steered w/ a
15" shaft.


I think I will look real hard at the Yamaha 40 tiller steer, I just hate to
spen $3,800, without knowing if it's the right choice.