On Mon, 11 Jul 2005 17:29:53 -0400, Mark wrote:

I have decided to replace the old floor in my 1986 Four Winns, as it
is start to get spongy and there is some rot in the hold compartment
underneath. My question is what method do any of you suggest to cut
out and remove the old floor. I would like to remove it in as few
pieces as poosible to have them as a templete. I am planning to use
good quality plywood and coat it with either epoxy or fiberglass.


We used a power jig saw with a judiciously chosen blade length on a
tri-hull floor (where the hull was as close as 1/2 inch away from the
floor....) Take care....

Brian Whatcott