I've found that when cutting out fiberglass pieces and wood is in the
vicinity, then a grinder with a cutting disc on it works great. I used the
cutting disc previously to cut steel, and it seemed to work great here too,
like cutting butter.
Just watch your breathing because of the dust. Can't recall if the disc got
hot or not too...


"Mark" wrote in message
...
I have decided to replace the old floor in my 1986 Four Winns, as it
is start to get spongy and there is some rot in the hold compartment
underneath. My question is what method do any of you suggest to cut
out and remove the old floor. I would like to remove it in as few
pieces as poosible to have them as a templete. I am planning to use
good quality plywood and coat it with either epoxy or fiberglass.