) writes:
I am a rank beginner attempting Herb McLeod's one sheet skiff. I
believe I've got the angles for the stem and frame figured out, but I'm
a little puzzled by the transom bevels given in the plans. The plans
say "Bevel on side 13 degrees" and "Bevel to bottom 18 degrees". I can


transom will be 90 deg to centreline. side will curve in to meet transom
at 13 deg.

bottom of boat is round fore-and-aft, called rocker, not flat. bottom of
boat is only flat side-to-side. rocker happens when you push the sides out
more at the top and then pull ends together. bottom curves up to meet
bottom of transom at 18 deg.

so cut or sand transom sides down 13 deg and bottom edge 18 deg.
doesn't have to be exact as adhesive will fill gap.


--
------------------------------------------------------------------------------
William R Watt National Capital FreeNet Ottawa's free community network
homepage: www.ncf.ca/~ag384/top.htm
warning: non-FreeNet email must have "notspam" in subject or it's returned