Andrew,
Another point to keep in mind is density. The difference between cast lead
at around 11+ tons per Cubic Meter and lead shot at 7 tons should persuade
you not to use resin and other methods for weights as other materials become
more viable at the lower densities.
Steve
"Andrew Butchart" wrote in message
...
I've come into possession of a quantity of lead wheel weights - about
70lbs
worth. I'd like to turn them into 10lb weights with an eyebolt on the
top.
One minor issue is that the weights were stored in an old grease pail and
so
are quite greasy.

As I see it I have three options:

- Melt it down and pour it into forms. The good thing with this, is that
the weights will be all lead. The bad thing is that I don't know how to
make forms - would wood be good enough, or old juice cans? Could I melt
the
lead on my BBQ - kitchen stove is out because of fumes of course. What
about the grease? Should I clean it off first? I'm not keen on this
method
because of all of the safety issues, but it give me the "best" and most
dense result.

- Use polyester resin and 1 litre cardboard milk cartons as a form to cast
a
weight. Would it hold together? Do I need to remove the grease from the
wheel weights?

- Put the weights into a large juice can and somehow seal up the top. I'd
worry about how solid this would be though.

Thanks

--
Andrew Butchart