Thread: No fire mariner
View Single Post
  #2   Report Post  
jchaplain
 
Posts: n/a
Default No fire mariner

On 27 Dec 2003 13:58:17 -0800, (kendot21) wrote:

I have a 1991 mariner 115 that has run like a champ until today. Last
trip out there was no indications of any problems and yet, today, I
have no fire (ignition). It has set idle for the past 5-6 weeks but I
can't for the life of me figure out how that might have caused this
failure. The only thing I have done is to install a depth finder and
I connected it to the "master" switch same as other accessories have
been connected to the power and in a circuit that is not supposed to
have any bearing on the engine (it only controls items like the bilge
pump, lights, livewell pump, etc.) Sooooo... any input would very much
be appreciated. If nothing else, I would like to have some idea of
what is causing my problem incase I have to resort to a repair shop
somewere.

Thanks ken

First of all, I would recommend that you get a repair manual. Having
schematics of the circuits of the engine is a good first step.
If you can't read a manual or schematics yourself, you'll need help (
like a repair shop.)
Check every known fuse on your boat ( and motor. There are fuses at
the motor often.)
Check for loose or disconnected wires. Perhaps you disconnected
something important when you were wiring your depth finder.
Check for 12 volts at the ignition coils when the key is on.
Does it turn over?