The new regs only apply in the US because we are the only country that
believes that government regulation can protect idiots from themselves.
The new valve has a float in it similar to a toilet tank that closes the
valve when the level reaches 80% full and a flow restrictor to prevent
drawing gas off faster than some arbitrary "safe" rate. Horzontal tanks and
tanks over 40 pounds are exempt. t has a male square thread for US filling
nozzels but still has the old style left hand female gas thread to keep it
compatable with existing equipment. That means that you can still get your
tanks refilled elsewhere.
BTW, you can get a new valve for about $19 at Northern Tool but it takes a 1
1/4" wrench and is a PITA to change out. It is really not worth it for a
steel tank but it might be for your aluminum tanks. I did it by wrapping a
ratchet type web holddown around the tank and clamping it in a vise.
--
Glenn Ashmore
I'm building a 45' cutter in strip/composite. Watch my progress (or lack
there of) at:
http://www.rutuonline.com
Shameless Commercial Division:
http://www.spade-anchor-us.com
"Skip Gundlach" skipgundlach sez use my name at earthlink dot fishcatcher
(net) - with apologies for the spamtrap wrote in message
...
Well, as we get nearer to our departure, I find myself reading of some of
the adventures of folks trying to get propane in parts of the world not
the
continental US. That brings two questions.
First and foremost is the US current mandate not to fill tanks with the
'old' style valves. Not bothering to be specific about the legislation,
the
new valves look different, and apparently have some safety features built
into them. They're recognizable in part by a triangular handle and some
markings. One may buy replacement valves in discount and home improvement
stores for only a slight premium - say, 30-50% - over surrendering an old
tank and taking a full replacement, complete with new, compliant valve,
from
their refilled tanks stand out front. How that makes sense is beyond me,
but, there you go.
As our boat has one each 20 and 10 pound aluminum tanks with the old style
valve, but one 20 with the current style, I wonder if the same refilling
restrictions exist outside the US. So, the question is, will our 'old
style' valves prove problematic outside the US? In particular, until we
get
the itch to do something else, it's unlikely we'd go beyond the Caribbean
basin - but that includes many countries' rules and regulations.
Which brings me to the second question. I've read in these parts about
the
inability to find propane which can be installed into our tanks in other
countries due to different valving normally found there. I've also read
of
some enterprising souls, usually on the foreign soil, who have fabricated
adapters to make it possible to have the local fitting mate to ours. Is
this sort of exercise likely to be necessary in the Caribbean (anywhere
from
Mexico in a loop through Venezuela to/through the Bahamas - and as a long
shot, perhaps Bermuda)? If so, in which countries/islands is this likely
to
be an issue? And, are there any commercially available sources for such
adapters?
Thanks.
L8R
Skip and Lydia
--
Morgan 461 #2
SV Flying Pig
http://tinyurl.com/384p2
"Twenty years from now you will be more disappointed by the things you
didn't do than by the ones you did do. So throw off the bowlines. Sail
away from the safe harbor. Catch the trade winds in your sails. Explore.
Dream. Discover." - Mark Twain