Thanks for the information. I will check to see if the original hose was
rated for diesel fuel.

Do you have a good source for diesel rated hose? West Marine has USCG and
NMMA approved hose but I would like to make sure there is no smell at all.
Maybe I should go with the refrigeration grade copper. I think that I can
make the run with one piece per side but it will be very difficult. The
current hose is very well mounted and I think I can use the same system
again.

I have never been on a boat that did not smell of Diesel that was so
equipped. I think I have a chance with metal lines.

Thanks
Mark

"DSK" wrote in message
. ..
plugster wrote:
The diesel fuel tank on my boat is in the center of my boat just forward
of
the mast and the engines are in the back so the fuel lines pass through
the
cabin. There are no fuel leaks, the lines are made from a gray rubber
and
smell strongly of the diesel fuel. The boat is 6 years old.

I'd bet the fuel lines are not an ABS-ABYC approved type for fuel.
Proper fuel line is expensive, but it lasts considerably more than 6
years.

... The runs are
about 45 feet and they do a fair amount of twists and turns. I am
thinking
about replacing them with soft metal tubing, maybe copper (Home Depot
water
tubing) or 3003-0 aluminum (aircraft grade fuel line).

Don't use aluminum on a boat. It corrodes far too quickly and is more
difficult to make up joints. Ask me how I know!

Refrigeration grade copper tubing (type L or M IIRC but check the specs)
is acceptable as fuel line... but it's difficult to install properly.
Unless you can rip out all obstacles, you have to snake it into place
and then mount it properly (it will work harden with vibration, and then
leak no matter what) and make up the terminal connections. This takes a
lot of time and careful work.


...Of course I will
leave a short flexible part near the engine for vibration.

You might as well go with the more expensive fuel hose for the whole
run. I'd recommend that, and I just did a somewhat shorter simpler job
on our trawler this past spring. Of course I work with tubing (HP air &
hydraulics, among other things) almost daily so the joint connections
were not a problem.

It'll cost more in dollars for material but take far less time & trouble
to install, and will be far less likely to leak due to bad joining.

Fresh Breezes- Doug King