On Sun, 18 May 2008 09:25:56 -0400, "Jim" wrote:


"John H." wrote in message
.. .
On Sun, 18 May 2008 12:46:36 GMT, Short Wave Sportfishing
wrote:

On Fri, 16 May 2008 16:20:06 -0400, John H.
wrote:

Anyone ever used them? West Marine has them on sale this week.

http://tinyurl.com/5pebls

Six of one, half dozen of the other.

I've had both of them, Fulton and Bearing Buddies. I can't tell the
difference except for the packaging. I've never had a problem with
either.

I suspect they are made by the same company and marketed seperate.
I've gone over them, compared side-by-each, measured and even took
both apart - there is no difference.

Just don't overfill them.

OK, another question:P

If I buy and install them, I'll have to grease them using a marine grease.
Now, I've read that different greases should not be mixed. Does this mean
that I need to track down the specific grease currently in the new trailer
hubs and match it, or will the addition of *any* marine grease work?
--
John *H*

You won't really know what's in the hubs unless you take them apart wash the
old grease out and repack with your preferred grease.
The trailer Mfr. might have used 1 product and the dealer might have used
something else to top off. Compatibility issues?
I bought an axle once that came packed with the thick stringy stuff. I had
to do the afore mentioned process to use my preferred grease. If your
trailer has brakes, you might need a special hi-temp grease.

No brakes, but this is starting to sound like a huge PITA. I may just wait
until the end of the season and install and repack at the same time.
--
John *H*

On Sun, 18 May 08, John H wrote:
this is starting to sound like a huge PITA. I may just wait
until the end of the season and install and repack at the same time.

..... or you can always replace the whole thing with the "oil bath"
type hubs. I bought a trailer with those recently but the jury will be
out for a few years while I decide whether or not I prefer them.

Rick