removing registration numbers
 

On Tue, 11 Sep 2007 18:05:10 -0400, "JimH" ask wrote:


"Don White" wrote in message
.. .

"Short Wave Sportfishing" wrote in message
...
On Tue, 11 Sep 2007 14:32:05 -0700, Chuck Gould
wrote:

On Sep 11, 1:38?pm, "Don White" wrote:
Finally got my new Canadian license numbers for the Princecraft Yukon.
(
kind off....they tell me the numbers and I have to go buy and apply
them)
Is a heat gun the best way to remove Tom's Connecticut numbers?

Be prepared to do a bit of buffing in the area where the CT numbers
were applied. You're likely to see the "ghost" of the CT numbers, and
you'll essentially have to grind away enough of the aged gelcoat
surrounding the part that was protected by the CT numbers to restore
an even appearance.

It's aluminum. Baked enamel paint. The boat was always stored inside
and/or covered.

The paint didn't fade.

Shiny as a new toonie....
Raining here for a couple of days but I plan on taking the boat down to
Cape Breton ASAP to cruise the beautiful Bras d'Or Lakes
see...
http://img.photobucket.com/albums/v2...n/HPIM0692.jpg
and
http://img.photobucket.com/albums/v2...n/HPIM0691.jpg


Nice job cleaning it up. How long did it take? ;-)

It was delivered in that condition. :)

removing registration numbers
 

On Tue, 11 Sep 2007 18:05:10 -0400, "JimH" ask wrote:

Nice job cleaning it up. How long did it take? ;-)

And you think that's clean, you ought to see my Ranger.

removing registration numbers
 

"Tom Francis" wrote in message
...

It was delivered in that condition. :)

Sure was...only dirt I could find to scrub was on the comfy padded seat.
I hosed it all down after last weeks run in the salt water of our North West
Arm.
Guess I'll buy a pair of 'ear muffs' to flush the motor after each salt
water outing. I'm surrounded by the sea but it's a half hour drive to any
worthwhile lakes.

removing registration numbers
 

Don White wrote:
"Tom Francis" wrote in message
...
It was delivered in that condition. :)

Sure was...only dirt I could find to scrub was on the comfy padded seat.
I hosed it all down after last weeks run in the salt water of our North West
Arm.
Guess I'll buy a pair of 'ear muffs' to flush the motor after each salt
water outing. I'm surrounded by the sea but it's a half hour drive to any
worthwhile lakes.



You ran it in salt water a week ago and didn't flush it? You might want
to get on that right away if it's not too late.

Dan

removing registration numbers
 

"Dan" intrceptor@gmaildotcom wrote in message
.. .
Don White wrote:
"Tom Francis" wrote in message
...
It was delivered in that condition. :)

Sure was...only dirt I could find to scrub was on the comfy padded seat.
I hosed it all down after last weeks run in the salt water of our North
West Arm.
Guess I'll buy a pair of 'ear muffs' to flush the motor after each salt
water outing. I'm surrounded by the sea but it's a half hour drive to
any worthwhile lakes.

You ran it in salt water a week ago and didn't flush it? You might want
to get on that right away if it's not too late.

Dan

Did last weeks flush in a large tub of water.
I'd better get the muffs though and do it in the street...last week I did it
right outside my neighbours window at supper time. (houses 15' apart)

removing registration numbers
 

"Short Wave Sportfishing" wrote in message
...
On Tue, 11 Sep 2007 18:05:10 -0400, "JimH" ask wrote:

Nice job cleaning it up. How long did it take? ;-)

And you think that's clean, you ought to see my Ranger.


BTW Tom...I sent you a direct e-mail re the X100 ETEC oil and other
things..

removing registration numbers
 

Don White wrote:
"Short Wave Sportfishing" wrote in message
...
On Tue, 11 Sep 2007 18:05:10 -0400, "JimH" ask wrote:

Nice job cleaning it up. How long did it take? ;-)
And you think that's clean, you ought to see my Ranger.


BTW Tom...I sent you a direct e-mail re the X100 ETEC oil and other
things..




Special oil for etecs?

removing registration numbers
 

Don White wrote:
"Dan" intrceptor@gmaildotcom wrote in message
.. .
Don White wrote:
"Tom Francis" wrote in message
...
It was delivered in that condition. :)
Sure was...only dirt I could find to scrub was on the comfy padded seat.
I hosed it all down after last weeks run in the salt water of our North
West Arm.
Guess I'll buy a pair of 'ear muffs' to flush the motor after each salt
water outing. I'm surrounded by the sea but it's a half hour drive to
any worthwhile lakes.
You ran it in salt water a week ago and didn't flush it? You might want
to get on that right away if it's not too late.

Dan

Did last weeks flush in a large tub of water.
I'd better get the muffs though and do it in the street...last week I did it
right outside my neighbours window at supper time. (houses 15' apart)



Don't skimp on the muffs. Get the type that sends water to both sides.
For a few dollars more it's worth the added insurance.

Dan

removing registration numbers
 

On Sep 11, 4:38 pm, "Don White" wrote:
Finally got my new Canadian license numbers for the Princecraft Yukon. (
kind off....they tell me the numbers and I have to go buy and apply them)
Is a heat gun the best way to remove Tom's Connecticut numbers?

You could just hang a stick of dynamite on each side...

removing registration numbers
 

On Tue, 11 Sep 2007 19:57:55 -0400, HK wrote:

Special oil for etecs?

Everyting about ETEC is special.

From their superior design, superior efficiency, superior emissions
and the fact that superior people who appreciate high technology buy
them.