A few questions....
 

Hi

I am currently putting together the interior of a small speedboat, its
my 1st boat so i have a few questions...if anyone can help would be
grateful..

1 Before i attach the ply side walls, is it wise to pack it out with
buoyancy aids..ie polystyrene?
2 Should i cut a hole in the side walls for access...right now all they
have is speaker holes.
3 Should i enclose the petrol tank or just make sure its secure?
4 Where is the best place to keep the battery? I realise no where near
the petrol tank!...do they come in enlosed casing?

Hope someone can give me some advice....

Cheers

A few questions....
 

3 Should i enclose the petrol tank or just make sure its secure?

Good question - I recall this was important. Depends on material, metal
tanks could be prone to corrosion if water can leak or condense on the
tank. I don't recall the specifics - I think it was in the Sorensen or
maybe Armstrong book...

Risto

A few questions....
 

Thanks....

Another question, im looking at getting a 75hp or higher engine, the
boat is a Sims Super v (15ft)....should i be looking to get a short
shaft or long shaft?

Cheers