trainfan1 wrote:

mlvosk wrote:

To make a long story short, my 1985 Evinrude 50 (2cyl) with a jet foot
attached just isn't quite enough to plane out 2 people at my 5000 ft+
altitude. So, lacking the funds for a new motor, I am converting it to
the 60 hp version, or at least attempting to. I understand this will
shorten the life of the motor and reduce the reliability, but not being
able to plane out is no fun either.

I have obtained 60 hp carbs and intake and was just about to install
them when I heard the exhaust may also need to be modified. I can
still obtain the exhaust parts if I need them but don't want to go
through the extra expense and hassle if I don't. Does anyone out there
know for sure if the exhaust differs between the 50 and 60 hp versions
of this motor and if so, what parts do I really need? Your help would
really be appreciated.

Thanks,
Mike


Is this the 35 Jet 2 cylinder looper?

Rob

Oh, you said '85. 35 Jet wasn't available yet from the factory.

You will need to get the parts diagrams & lists to compare the
mid-section exhaust tuner part numbers.

By '85, (since the 1976 55 hp) the 2 cylinder loopers(40-45-50-55-60)
shared the 45 CID displacement. I think the de-tuning was done at the
carb throat size.

Do you need the jet? Going back to a gearcase will give you more push
and allow you to easily change props to get the rpm range where it
should be.


Rob