I will keep the transducer away from the center line. I thought the
"avoid the center line" restriction only applied to "transom mounted"
transducer. I didn't know that it also applies to "shoot through hull"
transducer. Thanks for the warning.

Jay Chan


Russ K wrote:
Mounting the transducer at the center line is not recommended.This is
because the thickness of the hull .This would definitely cut down on the
return signal and make the readings erratic.
wrote in message
ups.com...
I would like to get some info about fishfinder:

1. Is this OK to mount a "shoot through hull" transducer right at the
center line of the boat hull? The center line of the bottom of the hull
is smooth; therefore, I am not expecting any turbulent at the center
line. The reason why I ask is that we are not supposed to mount a
transom-mount transducer at the center line where the outboard motor is
to avoid the turbulent from the propeller. I am hoping that this
restriction only applies to transom-mount transducer, and doesn't apply
to "shoot through hull" transducer.

2. Is "shoot through hull" transducer good enough for scanning the sea
bottom for fishes? In other words, I would like to know if I can use
the fishfinder as a fish-finder instead of using it as a depth-sounder
if I use a "shoot through hull" transducer. I only intend to use the
fishfinder in shallow water, like 10-ft to 150-ft; hopefully, losing
some range will not be a problem.

3. Does 3-D fishfinder present a relatively static picture instead of
scrolling endlessly like a regular fishfinder? I have a hard time to
interpret the scrolling image displayed in a regular fishfinder to
relate it to the sea bottom. I am hoping that a 3-D fishfinder can
solve this problem. Yes, I have already read a book about fishfinder;
but I still cannot interpret the scrolling image.

4. Is 3-D fishfinder any good? 3-D fishfinder seemed to be "hot" a
couple years or more ago. Recently when I checked Cabela's web site, I
could only find _one_ 3-D fishfinder. Is this 3-D technology too
immature that no other manufacturer wants to try?

Thanks in advance for any info.

Jay Chan