Ok, a very nice person read my post here about our
clutch slipping and recommended looking into the oil
we are using. I've been doing some research but
figured I'd also post here as it may interest others
and I know there is a wealth of knowledge here.

Situation: Our 1958 Chris Craft has a 6-Cylinder
model "M" engine. It has a Paragon transmission
that used discs (not gears) to engage power.

The transmission does not have separate fluid, but
uses the same motor-oil as the engine for it's lubrication.

When we get the boat up to about 2500 RPM the clutch
momentarily slips. We do have some instructions for
how to adjust the clutch, but it seems very hard to put
into gear already -- as if there is already plenty of
pressure on the plates.

What has been suggested is that newer motor oils
have more "anti-wear" additives and that these may
actually coat the metal-to-metal parts to keep them
from wearing. But in our case we *want* the metal
to metal parts of the clutch pressure plate to come
into contact with each other and *not* to slip past
each other.

Anyone have knowledge or ideas about this in
general and/or about Paragon transmissions?

Also, any recommendations on specific
motor oils to use that might be better for us?

Thanks,
Gary